Суич Hikvision DS-3E1318P-EI, 1000Mbps, 9 порта, 8x 10/100Mbps PoE, 1x 10/100/1000Mbps RJ45, 1x 10/100/1000 RJ45

HikvisionDS-3E1309P-EI

General
• Shell: Metal material, fan-free design
• Net Weight: 0.35 kg
• Gross Weight: 1.114 kg
• Dimensions (W × H × D): 170.00 mm × 27.60 mm × 93.10 mm
• Operating Temperature: 0 °C to 40 °C
• Storage Temperature: -40 °C to 85 °C
• Operating Humidity: 5% to 95% (no condensation)
• Relative Humidity: 5% to 95% (no condensation)
• Power Supply: 54VDC，2.22A
• Installation Mode: Desk-Mounted, Wall-Mounted
• Max. Power Consumption: 120W
• Power Consumption in Idle: 10W
• Surge Protection: 6 kV

Network Parameters
• Ports: 8× 10/100 Mbps PoE port, 1× Gigabit RJ45 port
• MAC Address Table: 8 K
• Packet Forwarding Rate
Whole-Device Performance: 4.17 Mpps
Port Performance: 2.68 Mpps
• Internal Cache: 4 Mbits
• Switching Capacity:
Whole-Device Performance: 5.6 Gbps
Port Performance: 3.6 Gbps

PoE Power Supply
• PoE Standard: IEEE 802.3af,IEEE 802.3at
• PoE Power Pin: End-span: 1/2(-), 3/6(+)
• PoE Port: PoE: Ports 1 to 8
• Max. Port Power: 30 W
• PoE Power Budget: 110 W

Software Function
• Long Range
Ports 1 to 8: up to 300 m.
Long range performance may vary depend on camera model or cable condition.
• Port Isolation
Ports 1 to 8: port isolation mode to improve network security
Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
• PoE Watchdog: Ports 1 to 8: auto detect and restart the cameras that do not respond.
• Loop Prevention
Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.
Support 802.1D STP.
Suppport 802.1w RSTP.
• VLAN
VLAN is used for network scale planning and network health improvement.
Support 802.1Q.
Configurable VLAN ID from 1-4094.
Support Trunk, Access port mode.
Support Max. 4094 VLAN.
• HPP
Support one-click activation and remote management via Hik-Partner Pro. Functions supported:
1. Display the port rate.
2. Display the port bandwidth utilization rate.
3. Display the PoE power usage.
4. Display topology information.
5. Display the alarm status.
6. Restart ports and devices.
7. Enable port long-rage mode.
8. Remotely upgrade the device.
• System Maintenance
Support device management via web.
Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.
Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.
Support management via Hik-Central Pro.
Support remote management via Hik-Partner Pro.
Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.
Supports 802.1ab LLDP for peer device discovery.
Support port mirroring for fault locating.

Виж още Суич Hikvision
Виж всички продукти Суич в категорията