Тонколона Genelec 6040R, 2.0, 300W RMS (150W + 150W), XLR, RJ-45, черна

The 6040R fuses the very best of Finnish technology and design, bringing exceptional performance and beautiful aesthetics to all lovers of high quality audio.

Smart Active Monitoring (SAM™) and GLM calibration technology

Directivity Control Waveguide (DCW) Technology

A loudspeaker ahead of its time 20 years after the launch of the original 6040A, the newly re-imagined 6040R now features professional grade LF drivers, proprietary Class D power amplifiers, and tight integration with our GLM calibration software. This allows the 6040R to deliver clean performance, a consistently smooth frequency response, precise imaging and low distortion – even in challenging acoustic environments.

Pure sound. Finnish design. Created in close collaboration with leading designer Harri Koskinen, the fluid curves of the 6040R are fashioned from die-cast recycled aluminium. Not only does this design approach create more truthful, less coloured loudspeaker performance, it also means that the 6040R will become the aural and visual centrepiece of any listening environment. Built to the highest environmental standards, the 6040R will provide decades of trouble-free performance.

Specifications

Frequency Response

50 Hz - 20 kHz (± 1.5 dB) 

Low cutoff -6dB
43 Hz

High cutoff -6dB
20 kHz 

SPL

Peak SPL
≥118 dB

Maximum peak acoustic output per pair in a listening room with music material at 1 m.

Short term max SPL
≥109 dB

Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.

Long term max SPL
≥98 dB

Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m.

Self-generated noise

Self-generated noise
≤5 dB SPL

Self generated noise level in free space at 1 m on axis (A-weighted).

Weight

Weight
14.9 kg (32.8 lb)

Dimensions

Height 
999 mm (39 3/8 in)

Width
237 mm (9 3/8 in)

Depth
220 mm (8 5/8 in)

Enclosure

Enclosure material
Die cast aluminium 

Enclosure type
Sealed box 

Group delay

The latency at high frequencies from the input to the acoustic output, measured in the analog input:

Extended Phase Linearity in GLM set to OFF 
2.9 ms

In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.

Amplifiers

6040R Treble Amplifier

150 W Class D

6040R bass amplifier

150 W Class D

Mains voltage

100-240 VAC 50/60Hz 

Power consumption

ISS Active
≤1 W

Idle
≤12 W

Full output
180 W

Connectors

Input

Analog signal input connector XLR female, balanced 10 kOhm.

Input

Digital signal input connector XLR female 110 Ohm.

Output

Digital signal output / Thru connector XLR male 110 Ohm.

2 x Control

Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.