Точка за достъп Cisco Aironet AP1852I-I-K9, 2.47GHz/5.32GHz(1700Mbps), 2x 10/100/1000 Gigabit Ethernet - RJ45, USB, Management console port (RJ-45)

Cisco Aironet AP1852I-I-K9

Cisco Aironet 1852i Access Point: Indoor environments, with internal antennas
● AIR-AP1852I-x-K9: Dual-band, controller-based 802.11a/g/n/ac, Wave 2

I (I regulatory domain):
● 2.412 to 2.472 GHz; 3 channels
● 5.180 to 5.320 GHz; 8 channels

Wireless LAN Standard IEEE 802.11ac
Frequency Band 2.47 GHz, 5.32 GHz
Wireless Transmission Speed 1.70 Gbit/s
MIMO Technology Yes
Beamforming Technology Yes
Interfaces/Ports:
Ethernet Technology Ethernet
Fast Ethernet
Gigabit Ethernet
Number of Network (RJ-45) Ports 2
PoE (RJ-45) Port No
VGA No
HDMI No
USB Yes
Powerline No
Management Port Yes
Power Description:
Power Source PoE
Power Supply
Physical Characteristics:
Height 2"
Width 8.3"
Depth 8.3"
Weight (Approximate) 3.12 lb

Software
Cisco Unified Wireless Network Software Release with AireOS wireless controllers:
● 8.1 MR1 or later for the Cisco Aironet 1850 Series Access Points

Deployment modes
Centralized local, Standalone*, Sniffer, Cisco FlexConnect™, Monitor**, OfficeExtend**, Mesh**

Supported wireless LAN controllers
● Cisco 2500 Series Wireless Controllers, Cisco Wireless Controller Module for ISR G2, Cisco Wireless Services Module 2 (WiSM2) for Catalyst® 6500 Series Switches, Cisco 5500 Series Wireless Controllers, Cisco Flex® 7500 Series Wireless Controllers, Cisco 8500 Series Wireless Controllers, Cisco 5760 Series Wireless Controllers**,
Cisco Catalyst 3650/3850 Series switch with integrated controller**
● Cisco Mobility Express

802.11n version 2.0 (and related) capabilities
● 4x4 MIMO with four spatial streams
● Maximal ratio combining (MRC)
● 20- and 40-MHz channels
● PHY data rates up to 600 Mbps (40 MHz with 5 GHz)
● Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)
● 802.11 dynamic frequency selection (DFS)
● Cyclic shift diversity (CSD) support

802.11ac Wave 1 and 2 capabilities
● 4x4 MIMO with four spatial streams, single-user MIMO
● 4x4 MIMO with three spatial streams, multiuser MIMO
● MRC
● 802.11ac beamforming (transmit beamforming)
● 20-, 40-, and 80-MHz channels
● PHY data rates up to 1.7 Gbps (80 MHz in 5 GHz)
● Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)
● 802.11 DFS
● CSD support
● Rogue device detection


Integrated antenna
● 2.4 GHz, gain 3 dBi, internal omni, horizontal beamwidth 360°
● 5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360°

Interfaces
● 1 x 10/100/1000BASE-T autosensing (RJ-45), Power over Ethernet (PoE)
● 1 x 10/100/1000BASE-T autosensing (RJ-45), AUX (used for Link Aggregation)
● Management console port (RJ-45)
● USB 2.0 (enabled via future software)

Indicators
● Status LED indicates boot loader status, association status, operating status, boot loader warnings, boot loader errors

Dimensions
(W x L x H)
● Access point (without mounting bracket): 8.3 x 8.3 x 2 in. (210.8 x 210.8 x 50.8 mm)

Weight
● 3.12 lb (1.41 kg)

Environmental
Cisco Aironet 1850i
● Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
● Nonoperating (storage) altitude test: 25˚C, 15,000 ft.
● Operating temperature: 32° to 104°F (0° to 40°C)
● Operating humidity: 10% to 90% (noncondensing)
● Operating altitude test: 40˚C, 9843 ft.
Cisco Aironet 1850e
● Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
● Nonoperating (storage) altitude test: 25˚C, 15,000 ft.
● Operating temperature: -4° to 122°F (-20° to 50°C)
● Operating humidity: 10% to 90% (noncondensing)
● Operating altitude test: 40˚C, 9843 ft.

System memory
● 1 GB DRAM
● 256 MB flash

Input power requirements
● AP1850: 44 to 57 VDC
● Power supply and power injector: 100 to 240 VAC; 50 to 60 Hz

Power draw
● 20.9W
Note: When deployed using a Power over Ethernet (PoE) specification, the power drawn from the power sourcing equipment will be higher by some amount, depending on the length of the interconnecting cable.

Powering options
● 802.3at
● Enhanced PoE
● Cisco power injector, AIR-PWRINJ4=
● Cisco local power supply, AIR-PWR-C=
● Cisco power injector, AIR-PWRINJ5= (Note: this injector supports 802.3af only)
● 802.3af
Note: If 802.3af PoE is the source of power, (1) the 1852e 2.4-GHz radio will shift to 2x3 from 3x4, (2) The USB port and AUX Ethernet port are disabled on both the 1852i and 1852e.
Warranty
Limited lifetime hardware warranty

Compliance standards
◦ UL 60950-1
◦ CAN/CSA-C22.2 No. 60950-1
◦ UL 2043
◦ IEC 60950-1
◦ EN 60950-1
◦ EN 50155
● Radio approvals:
◦ FCC Part 15.247, 15.407 *
◦ RSS-210 (Canada)
◦ EN 300.328, EN 301.893 (Europe)
◦ ARIB-STD 66 (Japan)
◦ ARIB-STD T71 (Japan)
◦ EMI and susceptibility (Class B)
◦ FCC Part 15.107 and 15.109 *
◦ ICES-003 (Canada)
◦ VCCI (Japan)
◦ EN 301.489-1 and -17 (Europe)
◦ EN 60601-1-2 EMC requirements for the Medical Directive 93/42/EEC
● IEEE standards:
◦ IEEE 802.11a/b/g, 802.11n, 802.11h, 802.11d
◦ IEEE 802.11ac Draft 5
● Security:
◦ 802.11i, Wi-Fi Protected Access 2 (WPA2), WPA
◦ 802.1X
◦ Advanced Encryption Standard (AES)
◦
● Extensible Authentication Protocol (EAP) types:
◦ EAP-Transport Layer Security (TLS)
◦ EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol Version 2 (MSCHAPv2)
◦ Protected EAP (PEAP) v0 or EAP-MSCHAPv2
◦ EAP-Flexible Authentication via Secure Tunneling (FAST)
◦ PEAP v1 or EAP-Generic Token Card (GTC)
◦ EAP-Subscriber Identity Module (SIM)
● Multimedia:
◦ Wi-Fi Multimedia (WMM)
● Other:
◦ FCC Bulletin OET-65C
◦ RSS-102

Виж още Аксеспойнт/Репитер Безжични Cisco
Виж всички Аксеспойнт/Репитер Безжични в категорията